Napatech FPGA SmartNICs Archives - Napatech Support Community

Question Category: Napatech FPGA SmartNICs

All Questions

Filter by

Questions Per Page:

Reflashing FPGA on NT20E2
Hi all. I have to tinker with an EoL Cisco appliance and a dead NT20E2 (also EoL, methinks) traffic capture …
tdrman Default Asked on December 10, 2024 in Napatech FPGA SmartNICs.
- 57 views
- 0 answers
- 0 votes
U.S. HTS and ECCN Request
Can you please provide U.S. HTS and ECCN classifications for part number NT80E3-2-PTP-ANL?
LogisticsPlus Default Asked on August 6, 2024 in Napatech FPGA SmartNICs.
- 230 views
- 1 answers
- 0 votes
Napatech Configuration
I have a NT200A02-01-SCC-2×100 Napatech and the latest driver is already installed, no error upon installation but upon starting the …
sdmzn Default Asked on July 9, 2024 in Napatech FPGA SmartNICs.
- 281 views
- 0 answers
- 0 votes
Getting Started with a NT4E-4 card
Hello Napatech Support, I recently installed a napatech NT4E-4 card into my PC. Apparently the card needs a driver …
Stormshalted Default Asked on June 14, 2024 in Napatech FPGA SmartNICs.
- 340 views
- 2 answers
- 0 votes
How to use TimeSync Anywhere port
Hi All, I have purchased a NAPATECH NT40E3-4-PTP 4x 10GbE Packet Capture Analysis SmartNIC for a hobby project to compare …
FPGA SmartNICs

Time Synchronization

lotusdew Default Asked on March 23, 2024 in Napatech FPGA SmartNICs.
- 376 views
- 1 answers
- 0 votes
Nagios (or similar) checks
Anyone have Nagios (or similar) checks to monitor NT40E3 capture performance?
CoryBrown Default Asked on August 16, 2023 in Napatech FPGA SmartNICs.
- 1K views
- 4 answers
- 0 votes
Problem to establish the link in NT40E3-4-PTP
I’m a new user and I’m having a problem establishing the link. The monitoring is reporting me a warning in …
FPGA SmartNICs

gustavosalge Default Asked on June 7, 2023 in Napatech FPGA SmartNICs.
- 3K views
- 7 answers
- 0 votes
Is it possible to read the RX sensor power level from command line
Would like to read the RX power levels for the ports and return just this value at command line – …
moraywilson Default Asked on May 30, 2023 in Napatech FPGA SmartNICs.
- 2K views
- 1 answers
- 0 votes
Profiling Streams are all 0
Hello, Under Monitoring I can see traffic are being captured, but under profiling, all streams are 0
sdmzn Default Asked on May 23, 2023 in Napatech FPGA SmartNICs.
- 2K views
- 5 answers
- 0 votes
NT40A11 PTP not supported confirmation
Hi community, I just wanted to confirm that, NT40A11 doesn’t support PTP like its predecessors NT40A01 and NT40E3. Please …
Andy_Awad Default Asked on February 2, 2023 in Napatech FPGA SmartNICs.
- 624 views
- 2 answers
- 0 votes

Latest Questions

Tags